Bleeding radiators’ is when you let out air that has become trapped inside. Trapped air causes the radiators to have cold spots, reducing the efficicency of them. You can bleed your radiators yourself, and it can vastly improve the efficiency of your entire heating sytem.
That means a warmer home and cheaper energy bills. Follow our easy step-by-step guide below.

Don’t want to do this job yourself? Then give Protea Property Maintenance on 02037731030 or 07939830056

Step 1:
Turn on the heating so that all radiators in your home come on.
Remember to wait until your radiators are fully heated before moving on to step two. You need to build up the pressure inside the radiator to be able to force the air out.

Step 2:
Once your radiators are hot, go and check each one individually to see if all parts of the radiator are warming up. Be careful – radiators can get very hot and you don’t want to burn yourself.

Cool spots, particularly toward the top of the radiator, mean that there could be air or gas trapped and that you’ll need to bleed that radiator.
Once you’ve found your cool spots it’s time to move onto step three and bleed them.

Don’t want to do this job yourself? Then give Protea Property Maintenance on 02037731030 or 07939830056

Step 3:
Switch off your central heating. This is reversing the process identified in step one and will allow you to handle the radiators without burning yourself or soaking your floor.

Bleeding radiators will require a radiator key (buy one at your local hardware store if you can’t find yours) or a flat-blade screwdriver.

At the top of the radiator at one end there will be a valve. You can attach the radiator key to the square bit in the centre or put the end of the screwdriver into the groove.

Hold the key or screwdriver with a cloth, and have another cloth ready to catch any drips, then slowly turn the radiator key or screwdriver anti-clockwise – if gas is escaping you’ll hear a hissing sound.

Once there is no more gas, liquid will come out and the valve will need to be closed quickly. With the more modern screwdriver operated escape valve, liquid is likely to emerge as a jet rather than a dribble.

Don’t want to do this job yourself? Then give Protea Property Maintenance on 02037731030 or 07939830056

Step 4:
Check the pressure by having a look at the gauge on your boiler. If the pressure is too low, you’ll need to ‘top up’. You can do this using the lever or tap on your boiler, known as the filling loop.

Afterwards, you may want to run another ‘hot test’ to check that your efforts have been successful. Simply turn your heating on, wait for all the radiators to heat up and check for any cool spots.

That’s it! Congratulations, now you know just how simple bleeding radiators can be!